HOW TO CLEAN INSTALL MAC OS X YOSEMITE SERIES
Cleared all audio-related patches (config entries for kext patches and realtekALC.kext), downloaded toleda's audio_CloverALC command for 10.10 ( ) and re-installed the audio.Īfter reboot I have HDMI-only audio, no other inputs/outputs, but I suppose that was expected for 9 series mb.Īt this point I ran migration assistant and brought all the data from the older Mavericks install. On reboot I saw that AppleIntelE1000e now loads fine, but this time the system did not boot at all - instead, it just went for an endless reboot loop.ģ. This kext showed up in kextstat, so I just did 'sudo touch /S/L/E' to rebuild the cache. The error was that it could not resolve the dependency to ''. AppleIntelE1000e failed to load during boot every time. I had to revert the volume from CoreStorage back to generic volume and then bootloader installer worked well.Īfter that, I just copied over the config, SSDTs and kexts from the Mavericks install, and expected a fully working system - but not just yet.Ģ. It took me a bit of time to realize that Yosemite installer converts the volume to CoreStorage which becomes 'disk1' and that seems to where Clover installer tries to install the loader. I could not install Clover on the boot partition after install. I have successfully installed Yosemite/Clover on my ASUS Z97-AR/Gigabyte GeForce GT740, but not without a bit of trouble.ġ.
Building a CustoMac Hackintosh: Buyer's Guide